Additional Information - JVC KD-A925BT Manuel D'instructions

Receiving/ending a phone call
When a call comes in, the source is
automatically changed to "BT FRONT/ BT REAR."
• "Receiving... [Phone number/name]" appears
on the display.
• The display will flash in blue. ("Ring Color,"
page 15)
When <Auto Answer> is activated....
The unit answers the incoming calls
automatically.
• Press or the control dial to answer
the incoming call when <Auto Answer> is
deactivated.
During a phone call conversation...
• Turn the control dial to adjust the phone
volume level [ 00 – 50 ]. [ Initial: VOL 15 ]
The adjustment made will not affect the other
sources.
• Press 5/∞ to adjust the microphone
sensitivity [ 1 – 3 ]. (As the number increases,
the microphone becomes more sensitive.)
• Press 4
/¢
Noise Reduction and Echo Cancelation mode.
To end an incoming call, press and hold
or the control dial.
Using the remote controller
5 / ∞ / 2 / 3 / SOURCE : [Press] Answers calls.

Additional information

• If you wish to perform complicated operations (such as dialing the numbers, using phonebook, etc.), stop your car in
a safe place.
• Some Bluetooth devices may not be connected to this unit depending on the Bluetooth version of the device.
• If you connect a different USB Bluetooth Adapter, all the registered devices and information will be cleared.
• This unit and some of the functions may not work for some Bluetooth devices.
• Connecting condition may vary depending on the circumstances around you.
• If you turn off the unit, detach the control panel, or unplug the USB Bluetooth Adapter during a phone call
conversation, the Bluetooth connection is disconnected. Continue the conversation using your mobile phone.
• When the unit is turned off, the device is disconnected.
• If you wish to receive more information about Bluetooth, visit the following JVC web site:
<http://www.jvc.co.jp/english/car/index.html> (English website only).
16 ENGLISH
to turn on/off the
[Hold] Rejects calls.
To switch conversation media (the unit/
mobile phone)
Press the control dial during a phone call
conversation, then continue your conversation
using the other media.
• Operations may be different according to the
connected Bluetooth device.
To switch between two connected mobile
phones
When two mobile phones are connected to the
unit, you can access to both "HF Menu" screens.
Press to access to the 1st phone's
"HF Menu" screen, press again to access to the
2nd phone's "HF Menu" screen.
• To return to the 1st phone's "HF Menu"
screen, press BACK.
Arriving of a text message
When a text message comes in, the unit rings
if your mobile phone is compatible with text
message and "Message Notice" is set to "On."
(page 15)
• "Received Message" appears and the display
illuminates in blue. ("Ring Color," page 15)
• You cannot read, edit, or send a message
through the unit.