Preparing For Use - proWIN Win-i Mode D'emploi

PREPARING FOR USE

1
2,5 - 3 liters
WARNING:
The suction unit has to be slightly covered with water for every operation.
The water tank is not dishwasher safe.
ATTACHING THE ENGINE HEAD TO WATER TANK
2
3
CLICK
4
54
(FOR AIR WASHING AND DRY VACUUM CLEANING)
1. Fill the water tank with approx. 2,5-3 liters cold water, so that the
suction unit is slightly covered (illus. 1), see also level indicator. Your
room cleaning system needs this water quantity for all functions
(except wet vacuum cleaning).
2. Ensure that the separator is attached properly.
1. Fit the engine head onto the water tank (Please pay attention to a soft
click-sound, when the motor head is positioned on the water tank. That
ensures that the motor head has been positioned correctly. If you don't
hear a click-sound, please repeat this procedure.).
2. First press the upper buckle down completely (illus. 2). Then hold
the lower part against the water tank so it can engage by closing
(illus. 3).
3. Now close the upper buckle until you hear a CLICK (Abb. 4).
NOTE:
First close the buckle BELOW then ABOVE (illus. 2-4).