Maintenance & Care - Bissell POWERFRESH LIFT-OFF 1897 Série Mode D'emploi

Operations
Using Your Steam Mop Cont'd
4. Grasp by steam mop handle and detent to
begin mopping.
5. Begin cleaning by slowly moving the unit over
the floor surface. Moisture on the floor is normal
when cleaning.
6. When the hard floor cleaner stops emitting
steam, turn the unit off and unplug. Verify if
there is water in the tank. If empty, refill the
water tank.
IMPORTANT: Sanitizing on timber floors is not recommended as prolonged application of
steam in one area increases the risk of damage to the surface treatment on timber floors,
especially in areas with regular foot traffic and direct sunlight, which will wear down
timber floor surface treatments making it more susceptible to steam damage.
Using the Lift-Off™ Pod
NOTE: When changing from mopping to hand
pod use, press the On/Off button to turn the
steam OFF and wait ten seconds.
1. Make sure the steam is OFF and wait ten
seconds.
2. Press the Lift-Off release button and pull
the hand pod out by handle.
3. With the connector or extension hose
attached to hand pod, connect the tool to
the opening.
4. Turn the tool in order to lock into place.
5. Press the On/Off button. Once the ready
light stops blinking and is solid, the heat up is
completed.
6. Press the Hi/Lo button, depending on volume
of steam desired.
7. ONLY then will the hand-held unit steam.
NOTE: The handheld steam pod will not operate without the proper attachments. You must
have the connector or extension hose attached for the steam to emit. A safety feature has
been designed to prevent steam emission without the connector or extension hose.
NOTE: Turn the steam OFF before removing or connecting tools and accessories.
Maintenance & Care
Removing All Mop Pads
1. Unplug hard floor cleaner from electrical outlet.
2. Carefully remove mop pad from the mop
pad tray using the Quick Release™ Tab. The
mop pad and tray may be hot.
3. The mop pad can be machine washed in
warm water. Use only liquid detergents. Do
not use fabric softeners or bleach. For best
results, air dry.
CAUTION
When removing the steam pod, built up steam may be
released. To avoid possible contact with steam, wait 10
seconds after turning unit off before removing the pod or
tools. Make sure to turn the steam OFF before removing or
connecting tools and accessories.
Extension Hose
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance.
CAUTION
Upright storage of the cleaner with a wet mop pad may
result in the formation of white marks on your floor. To
remove the white marks, clean area with vinegar.
www.BISSELL.com
Tool Connector
7