On/Off Models Only; Using The On/Off Display Unit - Rheem Raypak Crosswind-30-I Manuel D'installation

On/Off Models Only

The display controls general operation. The layout, main
functions and buttons are shown below.
WATER TEMP
AND
TIME SETTING
MODE
TIMER
INDICATOR
LIGHT B
TIMER ON
TIMER INDICATOR
LIGHT A
Figure 13. Operation Display, Models -40-O through -65-O
Symbol Designation
Power
Clock
Timer Off
Light A Shows the auto-stop time being set
Timer On
Light B Shows the auto-work time being set
Shows the cool mode (for heat and
Cool
Heat
MODE
MODE Key
available in heat and cool machine)
Down-
ARROW
Up-
ARROW
LED screen
Table F. Display Button Functions

Using the On/Off Display Unit

Display defaults
• The LED screen will display the time when the
machine is off.
• The LED screen will display the current water
temperature in the pool when the machine is on.
To change from Fahrenheit to Celsius, press and HOLD
the Timer ON button for 10 seconds to change from
.
°C
APPROVED
Heat
Cool
CLOCK
TIMER OFF
POWER ON/OFF
Button Functions
Power Switch
Set local time
Set the time required machine
auto-stop
Set the time required machine
auto-work
cool models only)
Shows the heat mode
Heat or cool mode selection (only
Set required temperature and time
Set required temperature and time
Display time, temperature and
machine failure code
UNCONTROLLED DOCUMENT IF PRINTED
Heat/Cool Mode
1. Press the MODE button to switch from one mode to
another.
NOTE: Available only in heat and cool models.
Setting pool water temperature
Temperature can be adjusted either when the machine is
on or off.
1. Press UP
water temperature.
2. The numbers on the LED screen will flash during
adjustment.
3. After five seconds of inactivity, the LED will stop
flashing, the adjusted target temperature will be
saved, and the LED screen will revert to the default
display.
4. Later on, at any time, if you want to check the
temperature setting, press UP
again to access its setting.
Setting the clock
1. The clock can be set either when the machine is on
or off.
2. Press CLOCK
zone. The displayed time on the LED screen will now
flash.
3. To set the hour press CLOCK
UP or DOWN
4. To set the minute press CLOCK
flashing and then press UP
5. After setting, press CLOCK
temperature will appears. After 30 seconds, it will
stop flashing and the LED screen will return to its
default.
Automatic on/off settings
The display can be programmed to turn the machine on
and off automatically.
Setting the ON time
1. Press CLOCK
2. When the indicator light is on and the time is flashing,
press CLOCK
or DOWN
3. While the display is still flashing, press
minute. Use UP
4. After adjustment, press TIMER ON
setting, and the water temperature will be displayed.
to
°F
After 30 seconds, the controller display will be revert
to its default mode.
or DOWN to set your target pool
or DOWN
to set the time to your local time
again, then press
.
before it stops
or DOWN
and the water
to access the timer function.
again to set the hour. Use UP
to adjust.
or DOWN to adjust.
.
to set
to confirm the
21