Citrus Press - Kenwood MultiPro FP925 Instructions

hints
Use fresh ingredients
●
Don't cut food too small. Fill the width of the large feed tube
●
fairly full. This prevents the food from slipping sideways during
processing. Alternatively use the small feed tube.
When using the chipper disc, place ingredients horizontally.
●
When slicing or shredding: food placed upright
●
shorter than food placed horizontally
There will always be a small amount of waste on the plate or in
●
the bowl after processing.
m u
lt i
p ro

citrus press

Use the citrus press to squeeze
the juice from citrus fruits (eg
oranges, lemons, limes and
grapefruits).
cone
sieve
to use the citrus
press
1 Fit the drive shaft and bowl
onto the power unit.
2 Fit the sieve into the bowl -
ensuring the sieve handle is
locked into position directly over
the bowl handle .
3 Place the cone over the drive
shaft turning until it drops all the way down
4 Cut the fruit in half. Then switch on and press the fruit onto the
cone.
The citrus press will not operate if the sieve is not
●
locked correctly.
comes out
.
m u
lt i
p ro
m u
lt i
p r
o
.
6
mini chopper/mill
Use the mini chopper/mill for milling herbs,
nuts and coffee beans.
blade unit
sealing ring
jar
sprinkler lid
safety
Never fit the blade unit to your machine
●
without the jar fitted.
Never unscrew the jar while the mini
●
chopper/mill is fitted to your machine.
Don't touch the sharp blades. Keep the
●
blade unit away from children.
Never remove the mini chopper/mill until the
●
blades have completely stopped.
Note: The mini chopper/mill base is
●
not interchangeable with the FP925
glass liquidiser jug. The processor will
not operate if the wrong base is fitted.
Refer to graphics on blade unit bases.
important
To ensure long life of your mini chopper/mill,
●
never run for longer than 30 seconds. Switch off
as soon as you've got the right consistency.
Don't process spices - they may damage the plastic.
●
The machine won't work if the mini chopper/mill is fitted
●
incorrectly.
Use for dry ingredients only.
●
to use your mini chopper/mill
1 Put your ingredients into the jar. Fill
it no more than half full.
2 Fit the sealing ring into the blade
unit.
3 Turn the blade unit upside down.
Lower it into the jar, blades down.
4 Screw the blade unit onto the jar
until it is finger tight.
5 Place the mini chopper/mill onto the
power unit and turn to lock
6 Switch on to maximum speed or
use the pulse control.
7 After milling, you can replace the blade unit with the sprinkler lid
and shake out your food.
The sprinkler lid is not airtight.
●
hints
Herbs are best milled when clean and dry.
●
m u
lt i
p ro
.