Dmx Controller - BoomToneDJ Evo II Led Mode D'emploi

5. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By DMX controller
Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other
units to give an automatic, sound activated. This function is good when you want an
instant show. You have to set the first unit in master mode,In the Stand Alone mode,
the units can be used without controller. You can do without a controller as the units
features a built-in microphone, which provides automatic sound control.. Its DMX
input jack will have nothing plugged into it. The other units will have to select
S-1,S-2,S-3,S-4 mode, Their DMX cables plugged into the DMX input jacks (daisy
chain) .

DMX Controller

Using universal DMX controller to control the units, you have to set DMX address
from 1 to 512 channel so that the units can receive DMX signal.
Press the MENU button up to when the A001 is showing on the display. Pressing ENTER button
. Use DOWN and UP button to change the DMX512 address. Once the address has been
selected, press and keep ENTER button pressed up to when the display stops blinking . To go
back to the functions without any change press the MENU button again.
13