Installation And Dismantlement; Connection Of The Signal Line Of The Wired Remote Controller; Installation Of The Wired Remote Controller - Gree XK19 Manuel D'utilisateur

Wired Remote Controller XK19

4 Installation and Dismantlement

4.1 Connection of the Signal Line of the Wired Remote Controller

● Open the cover of the electric control box of the indoor unit.
● Let the single line of the wired remote controller through the rubber ring.
● Connect the signal line of the wired remote controller to the 4-pin socket of the indoor unit
PCB.
● Tighten the signal wire with ties.
● The communication distance between the main board and the wired remote controller can
be up to 20 meters ( the standard distance is 8 meters)

4.2 Installation of the Wired Remote Controller

PVC Pipe
Fig.14 Accessories for the Installation of the Wired Remote Controller
No. 1
Socket box
Name embedded
in the wall
Table 3
2
Soleplate of the
Wired Remote
Controller
13
1
3
Front Panel of the
Screw
Wired Remote
M4X25
Controller
2 3 4
4 5
Screw ST2.9X6
5