Premium Service; Frequently Asked Questions - Philips WardrobeCare GC9940/05 Mode D'emploi

Question
Why does the system
keep beeping and
flashing?
Guarantee restrictions
- The guarantee does not cover products and/or product parts that are
subject to wear or that can be considered consumable parts by their
nature, such as anti-calc cartridges and ironing board covers.
- If the appliance is used improperly or for professional or semi-
professional purposes or if it is not used according to the instructions
in this user manual, the guarantee becomes invalid and Philips refuses
liability for any damage caused.
- The guarantee is not valid if a defect is due to damage caused by
incorrect use, poor maintenance or if alterations or repairs have been
carried out by persons not authorised by Philips Consumer Lifestyle.
Note: These guarantee restrictions do not affect your statutory rights.

Premium service

We want to ensure that you remain satisfied with your Philips
WardrobeCare System. We would like to remind you to register your
purchase on www.philips.com/welcome so that we can stay in contact with
you and send you maintenance reminders.
If you have questions about your Wardrobe Care system, e.g. about its use,
maintenance or descaling, or if you need new anti-calc cartridges, please go
to www.philips.com/support or call the free local Philips hotline. You find its
phone number in the separate guarantee leaflet.
We have put maximum effort in designing, developing and testing this high-
quality product. In the unfortunate case that your Wardrobe Care system
needs repair, please contact the nearest authorised Philips service centre
or call the free local Philips hotline. They will help you arrange the repair in
minimum time.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance.
If you cannot find the answer to your question, contact the Consumer
Care Centre in your country.
Answer
When the red REPLACE CARTRIDGE light flashes, the anti-calc cartridge has
lost its effectiveness and needs to be replaced. If you do not replace the used
anti-calc cartridge, the red REPLACE CARTRIDGE light stops flashing and
the appliance stops beeping. The Dual Protect Anti-Calc system automatically
switches off the appliance and it cannot be switched on again until the anti-
calc cartridge has been replaced.
When the blue AUTO CALC CLEAN light flashes, the system is performing
the Auto Calc Clean process.
When the red light on the water tank flashes, there is not enough water or
the water tank is not placed in the water tank compartment properly. Fill the
water tank and put it back into the water tank compartment properly.
If the red light on the rinse tray flashes, the Auto Calc Clean process is finished.
Empty the rinse tray and place it back before you switch on the iron again.
EnGlIsh
19