Setting The Spotlight Into Operation; Operation; Operation Without Dmx Controller; Automatic Mode - Stage Line electronic PARL-17DMX Mode D'emploi

5

Setting the Spotlight into Operation

GB
WARNING To prevent damage to your eyes,
never look directly into the light
source for a long time.
Please note that fast changes in
lighting, e. g. flashing light, may trig-
ger epileptic seizures with photosen-
sitive persons or persons with
epilepsy!
Connect the mains cable provided to the mains
jack (7) first, then connect it to a socket (230 V~/
50 Hz). Thus, the spotlight is ready for operation.
Operate it via a DMX light controller (
or on its own using the automatic control program
adjusted (chapter 7). To switch off, disconnect the
mains plug from the socket.
For a more convenient operation, it is recom-
mended to connect the unit to a mains socket
which is switched on and off via a light switch.
Caution: Never connect the unit to the mains volt-
age via a dimmer!
PARL-172DMX: The unit is protected against over-
heating; it will automatically switch off when the
temperature is too high and switch on again after
cooling down.
6

Operation

The settings of the spotlight are made via a system
menu to be operated via the buttons (4) and the dis-
play (3). After switching on the power supply, the
display shows the last setting made.
The buttons have the following functions:
– Button MENU / ESC to return to the higher menu
level
– Buttons and
set values or menu options
– Button ENTER to activate the menu item and to
go to the next parameter
The menu structure can be found in chapter 10.2.
Use the buttons to make the desired settings for the
corresponding operating mode according to chap-
ters 7 to 9. The display is switched off a few
seconds after the last button was pressed; it is
switched on again when a button is pressed.
Important: To make sure that a setting remains
memorized when the power supply is switched on
again, wait for 10 seconds after making the setting
before exiting the submenu. (When the setting is
being memorized, the display will briefly flicker.)
12
chapter 8)
to select a menu item and to
7

Operation without DMX Controller

7.1 Automatic mode

The unit offers two automatic show programs.
"Auto 1": colour sequence with crossfading
"Auto 2": stroboscope
To activate one of these programs:
1) Press the button MENU / ESC repeatedly until
you enter the main menu.
2) Select the option
button or .
3) Press the button ENTER: The last program
adjusted ( or
on the display. Select one of the two programs
with the button or
4) To change the speed, press the button ENTER:
The current speed is shown. Select one of the 9
speeds to

7.2 Music control

For music control of the spotlight via its microphone
(9) two music modes are available:
"Sound 1": all LEDs lighting up at the same time by
music control
"Sound 2": LEDs lighting up with changing colours
by music control
1) Press the button MENU / ESC repeatedly until
you enter the main menu.
2) Select the option
button or .
3) Press the button ENTER: The last music mode
adjusted ( oder
shown on the display. Select one of the two
modes with the button

7.3 Floodlight mode

For radiating a single colour continuously, the spot-
light offers nine preset colours and one colour to be
individually adjusted.
1) Press the button MENU / ESC repeatedly until
you enter the main menu.
2) Select the option
the button or .
3) Press the button ENTER: The last colour mode
adjusted (one of the preset colours
or the individual colour setting
activated and shown on the display. Select the
desired colour mode with the button
in the main menu with the
) is activated and shown
.
with the button or
in the main menu with the
) is activated and
or .
in the main menu with
or
.
...
) is
.