Ordering Replacement Parts - EINHELL UZS 18/250 Mode D'emploi

Anleitung UZS 18-250 SPK 1
GB
9.1.4. Making bevel cuts (Fig. 17/23)
Bevel cuts must always be used using the parallel
stop (7).
Set the blade (4) to the desired angle. (See 8.5.)
Set the parallel stop (7) in accordance with the
workpiece width and height (see 8.3.1)
Carry out the cut in accordance with the
workpiece width (see 9.1.1., 9.1.2 and 9.1.3.)
9.1.5. Making cross cuts (Fig. 18/24)
Cross cuts are made with the help of the drag
function.
Set the saw blade to the desired angle (Section
8.5).
Use the universal stop as explained in Section
8.4.
Hold the workpiece firmly with one hand and
press it against the stop rail.
With the other hand slowly pull the saw blade on
the drag device (8) forwards through the
workpiece.
When you have finished the cut, do not allow the
saw unit to jump back into starting position on its
own but guide it back slowly by hand.
Switch off the saw again.
Do not remove the offcut until the blade has
stopped rotating.
10.0. Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
Keep the saw unit drag device clean and
lubricate it in regular intervals.

11.0. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Model/type of device
Article number of the device
ID number of device
Number of the required replacement part
For our latest prices and information please go to
www.isc-gmbh.info
22
17.03.2005 9:32 Uhr Seite 22