Charging Batteries - Team Orion advantage one Mode D'emploi

CHARGING BATTERIES

WARNING! Always use charge settings which
a
are compatible with the battery. Always monitor the
charging process. Always disconnect the battery
from the charger once the charge is finished. Always
end the charging process if the battery becomes hot
to the touch or starts to change form (swell) during
the charge process. Failure to carefully setup the
charger and supervise the charge process can result
in fire, property damage or injury!
Battery connectors : two charge leads with one battery
connector type are supplied with the charger (Deans or
EC3, depending on the version). If your battery uses a
different type of connector, you will have to purchase a
compatible charge lead or adapter separately.
Adapters : a Deans to Tamiya adapter is also included with
certain versions of the charger. This allows you to charge
batteries equipped with Tamiya connectors by connecting
the adapter between the battery and charge lead..
Safety timer : The integrated safety timer will stop any
process after 120 minutes whether the battery is full or not
(the safety timer setting can be modified in the advanced
settings).
YOU CAN STOP THE CHARGE PROCESS AT ANY TIME
BY PRESSING THE ENTER/START/STOP KEY!
www.teamorion.com
Charging LiPo/LiFe batteries
WARNING! LiPo/LiFe batteries must be equipped
a
with two connectors, one for charging and one for
balancing! Never charge a LiPo/LiFe battery without
connecting its balancing connector to the correct
balancing port on the charger! Never use NiMH/NiCd
mode to charge a LiPo/LiFe battery, this will likely
cause the battery to overcharge and risk causing
fire, property damage and personal injury.
CHARGING LIPO/LIFE BATTERIES WITHOUT
a
BALANCING IS NOT POSSIBLE.
Balancing : The charger's integrated balancing ports
use JST-XH type connectors. If your battery uses another
connector type, you will have to purchase compatible
adapters. LiPo/LiFe batteries use different balance connec-
tors depending on the number of cells inside them; make
sure that you are connecting the balancing connector into
the correct balance port. The balancing function allows
the charger to measure the battery individual cells voltage
and adapt the charge process accordingly. Depending on
the cells unbalance and battery state, the charge will take
more or less time to complete.
English - 17