Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WP-440 Mode D'emploi

8

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

Toothbrush Tip
Place the toothbrush tip in mouth with
the brush head on the tooth at the
gumline. The toothbrush tip can be
used with or without toothpaste. Turn the Water Flosser on so the water flows
through the tip. Using a light pressure (bristles should not bend) massage
the brush back and forth with very short strokes-much like you would with a
manual toothbrush.
Plaque Seeker ® Tip
To use the Plaque Seeker Tip,
®
place the tip close to the teeth so
that the bristles are gently touching
the teeth. Gently glide tip along gumline, pausing briefly between teeth to
gently brush and allow the water to flow between the teeth.

WATER FLOSSER

®
Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit
to prevent clogging by partially filling reservoir with warm water and
running unit with tip pointed into sink until unit is empty.
Cleaning
Never immerse unit in water. Before cleaning, unplug from the electrical
outlet. Clean the product when necessary by using a soft cloth and mild
non-abrasive cleanser to wipe exterior.
The water reservoir is removable for easy cleaning and is top rack
dishwasher safe. It is recommended that the reservoir is removed and
cleaned weekly.
Removing Hard Water Deposits
Add 1 tablespoon of white vinegar to a full reservoir of warm water. Point
the handle and tip into sink. Turn unit ON and run until reservoir is empty.
Rinse by repeating with a full reservoir of clean warm water.
Battery Care and Disposal
The unit will not charge if the switch is in the ON position. If you use
your Water Flosser once a day or less, it is recommended you charge it