Troubleshooting - EGO PSX2500 Manuel De L'opérateur

TROUBLESHOOTING

PROBLEM
Pole saw does
not run.
Motor runs,
but chain does
not rotate.
Pole saw
does not cut
properly.
34
POLE SAW ATTACHMENT — PSX2500/PSX2500-FC
CAUSE
◾
No electrical contact between
the saw and battery pack.
◾
The battery pack is depleted.
◾
Bad connection between the
power pole and pole saw
attachment.
◾
The battery pack or power
pole is too hot.
◾
Debris in bar groove
◾
Debris in chain-sprocket
cover.
◾
Chain does not engage drive
sprocket.
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
SOLUTION
◾
Remove the battery pack, check
contacts and reattach the battery pack.
◾
Charge the battery pack.
◾
Remove pole saw attachment,
check contacts and reconnect it to
power pole, following the section
"CONNECTING THE POLE SAW
ATTACHMENT TO THE TELESCOPIC
POWER POLE"
◾
Allow the battery pack or power pole to
cool down before restarting the tool.
◾
Clear the debris in the groove.
◾
Remove battery pack, then remove
chain-sprocket cover and clean out
debris.
◾
Remove the battery pack and reinstall
the chain, making sure that the drive
links on the chain are fully seated on
the sprocket.
◾
Remove the battery pack and readjust
the chain tension, following the section
"ADJUSTING THE CHAIN TENSION".
◾
Sharpen the chain cutters, following
the section "How to Sharpen the
Cutters".
◾
Remove the battery pack and
reinstall the saw chain, following the
section"REPLACING THE BAR AND
CHAIN".
◾
Replace the chain following the
section"REPLACING THE BAR AND
CHAIN".