Limbing And Pruning - EGO PSX2500 Manuel De L'opérateur

Masquer les pouces Voir aussi pour PSX2500:

Table des Matières

Les langues disponibles

BASIC CUTTING PROCEDURE

(Fig. 5 AND 6)

Follow the steps below to prevent

damage to tree or shrub bark. Do not use

a back-and-forth sawing motion.

1. Make a shallow first cut (1/4 of the

limb diameter) on the underside of

the limb, close to the main limb or

trunk.

2. Make the second cut from the top

side of the limb, outboard from the

first cut. Continue the cut through

the limb until the limb separates

from the tree. Be prepared to

balance the weight of the tool when

the limb falls.

3. Make a final cut close to trunk.

NOTICE:

For second and final cuts (from

the top of the limb or branch), hold the bucking spikes against the limb being cut (Fig.

6). This will help to steady the limb and make it easier to cut. Allow the chain to cut for

you; exert only light downward pressure. If you force the cut, damage to the bar, chain,

or motor can result.

4. Release the trigger on the power pole as soon as the cut is completed.

NOTICE:

Failure to follow proper cutting procedures will result in the bar and chain

binding and becoming pinched or trapped in the limb. If this happens:

1. Switch off the tool and remove the battery pack.

2. If the limb can be reached from the ground, lift the limb while holding the saw.

This should release the "pinch" and get away the saw.