Instructions; Battery Installation; Operating Instructions - THINK GIZMOS TG630 ROBOATTACK Manuel D'utilisation

2. INSTRUCTIONS

2.1 Battery Installation

1. Before changing batteries, ensure RoboAttack is switched OFF.
2. Using a screwdriver, carefully unscrew the battery cover.
3. For the Robot, insert 4xAA batteries into the compartment making sure you follow the
layout for polarity (fig1).
4. For the Remote Control, insert 2xAA batteries into the compartment making sure you
follow the layout for polarity (fig2).
5. Carefully replace the battery compartment cover and tighten screw until hand tight.

2.2 Operating Instructions

1. Turning On: On the back-right of the Robot, push the switch to the "on" position. The
lights of the robot will start flashing and the robot will make its starting sound.
2. Controlling: Wait until this sound has finished. The robot will then enter "standby" mode.
You can now take control of the robot using the supplied remote control.
9
3
Indicator
7
10
3. Turning Off: On the back-right of the robot, push the switch to the "Off" position. The
Robot's lights will turn off and the Robot is now powered off.
Fig 1
RC Receiver LED
1
4
2
5
8
6
Fig 2
Press Key (1): Stride Forward.
Press Key (2): Stride Backward.
Press Key (3): Turn to the Left.
Press Key (4): Turn to the Right.
Press Key (5): Slide Forward.
Press Key (6): Slide Backward.
Press Key (7): Raise arm and fire gun.
Press Key (8): Launch Missile.
Press Key (9): Dance.
Press Key (10): Cancel Action.
4