Visual Inspection Of The Flame - Dometic OG2000 Mode D'emploi

OG2000 - OG3000
Manual ignition of the grill
If the electronic ignition does not work, the manual ignition is used as a
substitute.
To generate the flame, fully press down the control knob and turn it from
h
position grill (Fig. 6, page 6).
Simultaneously ignite the burner with a match or gas lighter.
h
Once the flame has been generated, press the knob down for a few
h
seconds so that the flame remains lit.
CAUTION!
If the burner does not turn on:
● check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact
your dealer.
Regulating the grill flame
The grill is to be used only at its rated thermal capacity.
h

7.4 Visual inspection of the flame

Depending on the type of gas used, the flame appears as follows:
● Propane (G31): flame with blue internal pin point and clear outline.
● Butane (G30): flame with slight yellow tips when igniting the burner;
these tips intensify as the burner heats.
EN
Use
39