Philips Lumea BRI864 Mode D'emploi page 22

22
English
22_100_5515_2_DFU-Luxury_A6_v3.indd 22
5 Press the device firmly onto your skin to
ensure proper skin contact. The 'ready to flash'
light lights up green to indicate that you can
proceed with the treatment.
Note: When the 'ready to flash' light starts blinking
orange, your skin is not suitable for treatment. In
this case, the device automatically disables. You
can try to use the device on other areas with a
lighter skin tone.
Note: If the ' ready to flash' light does not light up
green, the device is not completely in contact with
your skin.
TIP: If you use Lumea on your bikini area and
want to leave some hair in place, make sure
that the skin tone sensor is not placed on the
remaining hair during the treatment, as this can
cause the device to block
6 Press the flash button to release a flash.
The devices makes a soft popping sound.
You should feel a warm sensation because
of the flash.
Note: The scattered light produced by the device is
harmless to your eyes. It is not necessary to wear
goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
7 Place the device on the next area to be treated.
After each flash, it takes up to 2 seconds until
the device is ready to flash again. You can
release a flash when the 'ready to flash' light
lights up green.
23/06/16 10:15