Jam Zero Chill Livret D'instructions page 5

D – WATER & DUST PROOF
The smart folks who made this speaker designed it to
keep the party going through just about anything (they
call it IP67). This means that Zero Chill is dust proof, and
submersible in water up to 1 meter (3ft) for 30 minutes.
But those designers aren't miracle workers. Doing
something like dropping your speaker from Mount Everest
or taking it deep-sea diving will damage your speaker and
prevent it from emitting the incredible sounds it is made
to. Always keep the side and bottom flaps flush with the
speaker when you are using it near water, or it could be
damaged.
E – CALL HANDLING
While rocking out to your music, if a call comes in, short
press the "play/pause" button to pick it up; short press
again when you're done, to hang up.
While on a call, if you want to make it private, long press
the "play/pause" button to move the call from the speaker
to your phone.
If a call comes in and you don't want to pick it up,
long press the "play/pause" button to send the call
to voicemail.
* See the tables on the following pages for complete
button function and LED light indicator interpretation.
F – PAIR 2 ZERO CHILL SPEAKERS
1. Turn on speaker 1 (press and hold the "play/pause"
button for 3 seconds).
2. Turn on speaker 2 (press and hold the "play/pause"
button for 3 seconds).
3. On both speakers, press and hold the "X" and "O"
buttons at the same time for up to 4 seconds and
wait for a tone and the lights to blink green.
4. The speakers will begin to pair together. This will take
a few seconds.
5. Tone prompt will indicate when speakers are paired
together.
6. Choose "Zero Chill" from your device's Bluetooth list.
7. Press the "play/pause" button on either speaker to
listen to music. Press "X" and "O" together to toggle
between stereo and mono modes.
8. Once paired, your speakers will recognize each other
every time both are turned on. To disconnect Pair 2
mode, press and hold the "X" and "O" buttons for up to
4 seconds. This will enter into pairing mode again.
Note: If either of your speakers has been previously paired
to a device, or will not pair automatically, press and hold
the "play/pause" and "X" buttons on both speakers for 5
seconds to activate pairing mode. You will know they have
reached pairing mode by the red and blue blinking light.
EN
AUX
CHARGE
...0.5s
...0.5s
...3s
...3s
...4s
Zero
0000
Chill
Zero
0000
Chill
...2s
5