teutonia Bliss Mode D'emploi page 13

Special features of the model variations
justment screw on the brake lever.
Note: The brake should only be used to slow the
wheels, not to block them.
Maintenance:
- The brake pads can wear out during use and the
brake needs maintenance. The setting of the brake
can be done on the brake lever when the lock nut is
loosened and the adjusting bolt is unscrewed.
- If the left and right braking effect differs, tilt over the
stroller on soft ground and adjust the bolt under the
brake housings near the wheels.
- The bolt can be screwed and unscrewed by using an
8mm jaw wrench. Unscrewing the bolt increases the
braking effect. The setting has to be made so that
the braking effect is the same on both wheels.
Fixing and Releasing the seat
WARNING: Check that the seat unit attach-
ment devices are correctly engaged before
use.
Models with deceleration
brake:
You are able to control the
deceleration brake using
the brake on the handlebar.
The braking action can be
fine-tuned using the ad-
Safety bar
Handling the hood
To attach:
Push the connectors of the hood adjustment joints
into the sockets of the armrests and fix the press-
studs at the back side of the hood cover onto the
corresponding complements at the rear side of the
backrest.
To remove:
Open the press-studs at the backside of the hood
cover, press the release buttons at the connectors
and pull the hood off.
13