Portable Winch PCA-1263 Guide Rapide

Using the tree/pole mount with anchor strap (
1) Place the tree/pole mount at the base of the tree or pole. Insert the strap's hook into the anchor point on the left (figure 1, no 1); then feed the strap's end
through the ratchet system (figure 1, no 2);
2) Slide the whole set-up upward to the desired height (figure 2);
3) Tighten the sling with the wrench supplied (figure 3) while making sure the rubber pads are properly positioned. The pads should offer maximum contact
surface with the tree or pole;
4) Install the receiver hitch (not included) without the square tubing and fasten it with the hitch pin and ''R'' pin (figure 4);
5) Attach the winch anchor hooks to the eye bolts (figure 5);
6) Wrap the rope around the drum and start winching. The winch will align itself automatically with the load (figure 6).
I
F YOU NEED TO PULL DOWNWARD
A
FTER PULLING FOR A FEW SECONDS WITH THE TREE
THE INSTALLATION AND TIGHTEN THE SLING AGAIN
PCA-1263 - TREE/POLE MOUNT
Includes: 1 x Tree/pole mount, 1 x strap, 1 hex wrench, 1 carabiner
USER MANUAL
REFER TO WINCH
,
YOU WILL NEED TO INSTALL EITHER A PULLEY OR A ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT PLATE
/
POLE MOUNT
.
)
FOR MORE INFO
, P
RELEASE THE TENSION OFF THE
C W . C
ORTABLE APSTAN INCH HECK THE SOLIDITY OF
NOTE: The hex wrench can be stored in the
opening on top of the tree mount (no. 1
above) and locked in position with the
provided carabiner (no. 2 above).
.