VONROC SP508AC Traduction De La Notice Originale page 8

EN
Pump is active Turbine clogged
but
no water is
being delivered
Pump will not Not the right
switch off operating mode
Sensor switch is
dirty
Pump will not Thermal overload
start or stops safety switch has
during use. activated
Pump switched
off after short
operating
periods Power has
tripped
Turbine clogged
Water too hot
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EU for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
8
period lawfully stipulated starting from the date of
Disconnect pump
original purchase. Should the product develop any
from the power
failure during this period due to defective material
supply and clean or
and/or workmanship then contact VONROC directly.
unblock the turbine
(see 'Blockages')
The following circumstances are excluded from this
Check the operation
guarantee:
mode. (see 'OPERA-
• Repairs and or alterations have been made
TION')
Clean the sensor
• Normal wear and tear;
switch
• The tool has been abused, misused or improp-
Disconnect from the
• Non-original spare parts have been used.
power supply, leave for
2 minutes and clear
This constitutes the sole warranty made by compa-
the turbine (if required
- see 'Blockages') ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
Check fuses and elec-
trical connections plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
Disconnect pump liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
from the power
supply and clean or replacement of nonconforming units or parts.
unblock the turbine
The product and the user manual are subject to
(see 'Blockages')
change. Specifications can be changed without
further notice.
Ensure that the water
temperature has
not exceeded the
maximum of 35°C
or attempted to the machine by unauthorized
service centers;
erly maintained;
WWW.VONROC.COM