How To Use - Black & Decker KE1560W Guide D'utilisation Et D'entretien

How to Use

This appliance is for household use only.
BEFORE USING YOUR KETTLE
Remove all packing materials, any stickers, and the plastic band around the power
•
plug.
To register your product, go to www.prodprotect.com/blackanddecker.
•
• Wash all parts as instructed in CARE AND CLEANING section.
• Select a level surface where this unit is to be used allowing enough space for
steam to escape without damage to counters, cabinets and walls.
• Fill kettle to maximum fill line with cold water. Bring to boil, discard and repeat.
Kettle is now ready for use.
Note: The kettle only operates when placed on the base with the ON/OFF (I/O)
button in the ON (I) position. The kettle automatically shuts off when water has
boiled or there is no water in the kettle.
Important:
• Do NOT fill the kettle with any substance other than water. Heat water only.
• Do NOT operate the kettle without water.
• Do NOT operate the kettle without the filter in place.
• Do NOT overfill the kettle. (Keep water level below the max fill line on the water
window.) If the kettle is overfilled, it may discharge boiling water.
• Do NOT attempt to heat the kettle on a stove top. Only operate the kettle on the base
that is included with the unit.
FILLING THE KETTLE
1. Remove the kettle from the base.
2. Push the lid release button to open the lid.
3. Make sure the removable filter is in place.
To install: put filter in kettle, aligning the triangular filter
with the inside/back of the pour spout. Attach the bottom
first, and then the top. (A)
4. Fill with desired amount of cold tap water. Use the water
level tabs inside the kettle as a guide for 1 to 3 cups of water.
Use the water window on the outside of the kettle as a guide for .5 liters up to 1.7
liters (7 cups).
5. Press the lid downward until it snaps closed.
6. Unwind cord from base.
7. Place the kettle securely on the base.
BOILING WATER
1. Plug cord on the base into standard electrical outlet.
2. Press the On/Off (I/O) switch to the On (I) position. The power indicator light turns
on and the water begins to heat.
4
A A