Medisana USN Mode D'emploi page 25

3.5
Preparation
for inhalation
3.6
Inhalation
Before operating for the first time or if the device has not been
used for some time, clean and disinfect the nebulizer chamber as
well as the mouthpiece and mask including the connecting piece
(also refer to "Cleaning and maintenance").
Remove the chamber cover
from the device and pour the
inhalant into the chamber
(maximum contents 6 ml =
6cc).
Please observe the dosage and
instructions for use on the
information leaflet enclosed
with the medicine you are
using.
If the inhalant is an essence,
first fill the chamber with isotonic saline solution and then add
the essence according to the dosage.
Close the chamber with the cover
fits correctly and is tight. If necessary, turn the cover until you
have found the right position. There is only one correct way of
fitting the chamber cover to the device.
Then attach the mouthpiece
mask onto the chamber cover.
IMPORTANT
Before starting therapy, discuss the length, dosage
and frequency of use with your doctor. The method
of use should be appropriate to the aim of the
therapy (e.g. lung treatment = use of mouthpiece
and treatment of the nasal-pharyngeal area = use of
mask). Consult your doctor about this aspect as well.
3 Operating
. Make sure that the cover
or the connecting piece and a
GB
21