GIESSE VARIA SLIM RADIO Manuel D'utilisation Et D'installation page 37

Some functions of the radio remote control are not discussed in this
manual.
T
HE TRANSMITTER IS
First follow the radio remote control instructions and then those provided
below concerning the specific operation of the machine you would like to
control.
10.1.1. Saving the radio remote control
The radio remote control supplied is the RC model, with 30 channels and a
display, which transmits at the radio frequency of 433.92 MHz; no other radio
remote control model is provided for the VARIA SLIM RADIO. Several actuators
can be controlled with a single radio remote control, however each channel must
correspond to a VARIA SLIM RADIO actuator and thus a window.
The encoding used varies for each channel, so each transmission will send a
signal that is different from all the others. It follows that the receiver must be able
to recognize the enabled transmitters, thus the transmission codes should be
saved following the procedure below:
▪ Equip yourself with the radio remote control, checking beforehand that it is
working, has charged batteries and is in good condition.
▪ Select the desired channel on the radio remote control. (Consult the
instructions manual of the RC radio remote control).
▪ On the VARIA SLIM RADIO, briefly press (for about 1 second) the small
" " button located near the terminal block. The slowly flashing LED
PRG
indicates that it is waiting to receive a valid radio code.
▪ Within 10 seconds, press any one of the up arrow ▲,
▼ buttons two times (once to activate the display of the radio remote
control and the second time to transmit the radio code).
▪ If the code is saved correctly, the LED will emit one long flash (1 sec.) to
confirm; then the LED will go out and remain at rest.
▪ If the code is not saved correctly - due to the memory being full, for
example, or the radio remote control being incompatible - the LED will emit
a series of quick flashes for about 1 second; then the LED will go out and
remain at rest.
10.1.2. Erasing the radio memory
To completely erase the memory of the radio remote control on the machine,
press the " " button and hold it pressed for about 20 seconds until the LED
PRG
begins to flash quickly. At this point you can release the button; the flashing
continues until the memory has been completely erased.
10.1.3. Remotely saving a radio remote control
A new radio remote control can be saved remotely – i.e., without accessing the
button – only if at least one radio remote control has already been saved as
PRG
NOT -
FACTORY PROGRAMMED
.
37
or down arrow
STOP