Charging The Battery; Power Connection; Charging Display - On Phone; Battery Charging Time - Audiovox CDM 8600 Manuel D'utilisation

CDM-8600BM7/22 2003.7.22 3:0 PM

CHARGING THE BATTERY

POWER CONNECTION

Connect the charger to a standard 110V AC outlet.
NOTE: 1. It is more efficient to charge the battery with
the handset off.
2. The battery must be connected to the phone in
order to charge it.
3. Battery operating time gradually decreases over
time.
4. If the battery fails to perform normally, you may
need to replace the battery.
CHARGING DISPLAY – ON PHONE
"Charging .... "
"Charging is Complete"
"Check Charger"
An error can occur for the following reasons:
Battery is not correctly attached to the phone.
Temperature is out of range for charging.
o
(Charging Temperature : 0 C ~ 50
Page 12 - Chapter 1
Page 14
CHARGING THE BATTERY

BATTERY CHARGING TIME

Battery Type
Charging Time
NOTE:
BATTERY TALK & STANDBY TIMES
Status
Talk Time (min)
Standby Time (hrs)
NOTE: These times are for a new battery.
Being Charged
Fully Charged
In Case of Error
o
C)
BTR- 8600
(900 mAh)
200 minutes
Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on.
Type
Digital Analog
190min 60min
150hrs
Talk and standby time may decrease over time.
Chapter 1 - Page 13
12hrs