Batteries - PLS HVR 505 Mode D'emploi

BATTERIES

The PLS HVR 505 uses rechargeable
NiMH batteries.
For on-board chargeable battery, insert
the battery re-charger receptacle plug in
the charging panel outlet of the battery
cover back.
Insert converter's AC receptacle plug in
an AC outlet and insert the converter's
DC receptacle plug in the charging panel's
DC outlet.
When the charging lamp is on, charging
is in process.
When the charging lamp is green, charging
is completed.
NOTE: The charging process takes
approximately 7 hours to complete for
rechargeable batteries.
AC/DC converter's suitable power range:
50-60Hz; voltage 85V-265V.
DO NOT USE ALKALINE BATTERIES
WITH YOUR PLS HVR 505.
If it is necessary to replace the NiMH
batteries, the battery chamber may be
removed with a Philips screwdriver.
Purchase replacement NiMH batteries
from an authorized dealer.
Use PLS HVR 505 with caution in humid
or wet weather conditions. Do not put the
laser back into the case unless it is thor-
oughly dry. Condensation may corrode the
battery connections and/or cause distortion
of beams in lighthouse.
3