Publicité
Les langues disponibles
Les langues disponibles
AFTER FINISHING WORK
one side with the filter
element facing
•
Switch off the cleaner
upwards (Fig. 9).
and pull the plug of
•
Unscrew the filter
the power cord out of
retaining nut (1) and
the plug socket.
remove together with
•
Wind up the power
the retaining washer
cord (Fig. 7).
(2).
·
Pull off the filter
element (3).
CHANGING THE BAG-
•
Push on a new filter
TYPE FILTER
element.
•
Fit the filter retaining
•
Close the bag-type
washer and tighten the
filter sleeve with the
retaining nut.
slide (Fig. 8).
•
Dispose of the used
•
Pull the bag-type filter
filter element in
sleeve off the inlet
accordance with the
fitting.
local waste disposal
•
Dispose of the used
regulations.
bag-type filter in
accordance with the
local waste disposal
TESTS AND APPROVALS
regulations.
•
Place a new bag-type
Electrotechnically tested
filter into the tank as
according to test
described in the
methods/principles:
instructions (printed
IEC 60335-1and
on the filter).
IEC 60335-2-69.
IMPORTANT!
As a result of these tests,
Push the bag-type
suitable for higher load
filter sleeve completely
for commercial
onto the inlet fitting.
application.
Electrotechnical tests must
REPLACING THE FILTER
be performed in
ELEMENT
accordance with the
provisions of the Accident
•
Switch off the cleaner
Prevention Regulations
and pull the plug of
(VBG4) and to DIN VDE
the power cord out of
0701 Part 1 and Part 3. In
the plug socket.
accordance with DIN VDE
•
Remove the cleaner
0702, these tests must be
top section from the
performed at regular
dirt tank and place to
intervals and after repair
or modification.
4
TROUBLESHOOTING
Problem
‡ Motor does not start
> Fuse of plug socket
has blown
> Overload protection
switch has tripped
‡ Reduced suction
> Bag-type filter full
power
> Suction hose clogged
> Filter element clogged
‡ No suction power
> Tank full (float switch
during wet cleaning
closing off the suction
opening)
Cause
Remedy
•
Reset the fuse
•
Allow the cleaner to
cool down for approx.
5 minutes; if the
cleaner does not start
again automatically,
contact the Service
Dept.
•
Replace bag-type filter
•
Clean suction hose
•
Clean or replace filter
element
•
Empty tank
5
Publicité
