Power Supply; Battery Change - Wittkopp Multicode Manuel D'utilisation

4. silent alarm
4.1 opening with alarm code
The lock opens normally after entering the alarm code. Simultaneously a relay is triggered in PrimorSignal plus by
which the alarm code can be signalled to a burglar alarm system. Alarm code: the number to be added to the last
number of the code. Usually this is 1.
Step
Enter the 7-digit alarm code e.g. 5678913+1
1.
Turn the handle within 3 seconds into opening position, the lock is opened
2.
• If the result becomes double-digit only the last number is taken (e.g. 9+1=10, enter only 0).

5.0 Power supply

5.1 battery change

The lock is power supplied by one 9V block battery alkaline (no rechargeable batteries!). When battery voltage is
insufficient, after entering the code a warning tone occurs repeatedly and the red LEDs flash alternately.
Change the battery as quickly as possible. The programmed codes stay valid during battery change. To change
batteries, open the keypad.
Always dispose used batteries in an environmentally friendly way.
Do you have questions about your safe, the electronic lock or is there an unexpected malfunction?
Please contact your local dealer.
18
Action Key
4
567891