Waeco PerfectCoffee MC05 Instructions De Montage Et De Service page 15

Fitting
The scope of delivery includes the fixing bracket which is very simple to
fit. The plastic angled bracket holder is provided with 4 mm diameter
holes for wall or floor mounting. The holder can be easily screwed to the
vehicle e.g. a shelf, in a caravan or a yacht on the rear wall of the galley
)
(see A 3a + 3b . Use the countersunk head screws, washers and nuts
(size M 4) to secure the plastic holder, these are commercially available
items.
Attention! To avoid damage when drilling holes ensure sufficient clear-
ance for the drill break-out.
To engage push the coffee maker MC-05 into the plastic holder
)
(see B 4a .
It can be released again by a light finger pressure
)
(see B 5 .
Attention! When fitting the coffee maker MC-10 in the fixing bracket
ensure that the foot of the coffee maker is in the recess of the fixing
)
bracket (see B 4b .
In the case of wall mounting and the corresponding free space below the
coffee maker can be additionally securely screwed in place using the a
)
knurled screw (see B 3b A .
A storage compartment is provided beneath the coffee maker for the cable
)
(see B 6a + 6b .
The glass jug is secured by a clamping clip, the retention strength can be
)
increased by turning to the rear (see B 7a + 7b .
15