Before Installation; System Connection - ANTARION ECRANSY Manuel D'installation Et D'utilisation

Introduction:
Thank you for purchasing our product for the safety and comfort of your vehicle. Despite its
uncomplicated installation, we recommend that you consult a professional to avoid damaging your
vehicle.

Before installation:

- Comply with the rules in force in your country for the use and installation of this product.
- For your safety, please observe the following installation instructions.
- The monitor must be placed in a location that provides good visibility for the driver.
- The system operates on 12V DC voltage only, check the vehicle voltage, and the polarity of each
connector.
- Before installation, check that all vehicle components function correctly, such as contact, starter, light
code ignition and headlights... And carry out the same tests after installation.
- Connect the wires only by soldering or splicing. Bad contacts can create serious vehicle and system
malfunctions.
- Make sure that the system is properly grounded.

System connection :

Screen
Attach the screen support using the supplied adhesive. If possible, also
screw this bracket to the defined location.
Slide the square of the bracket into the slide on the back of the screen,
adjust the height of the screen, then tighten the knob firmly.
The green wire connected to the +12V
reverse switch allows the system to switch
automatically as soon as the reverse gear is
switched on, even when it the system is
switched off.
English