Frame/Front Installation - Napoleon GT8N Mode D'emploi

5.4

frame/front installation

A.
Align the two holes in the upper portion
of the hinge on the control door to those
in the bottom trim bracket, secure using
two of the #8 x 1/2" hex head screws
supplied.
B.
Install the top trim bracket to the fi rebox
using the three #9 - 14 x 1/2" hex head
screws supplied in the
baggie.
C.
Rest the top lip of the
the top trim bracket, and the securing tabs at the bottom of the
D.
Align the two slots in the top of the
using the two #10 pan head screws supplied however do not fully tighten to leave room for adjustment.
E.
Align the holes in the securing tabs at the bottom of the
bracket and secure using the two remaining #8 x 1/2" hex
head screws, however do not fully tighten to leave room for
adjustment.
F.
If required, the bottom trim bracket can be adjusted by
loosening it's securing screws.
G.
Once the
door will close without rubbing against the sides of the
frame, tighten all screws.
H.
Open the control door.
I.
Insert the door stop chain into the receiving slot in the control
door.
J.
Insert the door stop chain into the receiving slot in the
frame so that when fully open the control door has a
clearance of 1/8" to the fi nished wall. NOTE: In most cases,
a count of 9 balls between receiving slots will give the
desired clearance.
K.
Close the control door.
The frame has been designed to accommodate fi nished
material thicknesses of 1/2" - 3/4" (13mm - 19mm). If it is necessary
to pull the frame out to the max. 3/4" (19mm) the magnetic
catch will need to be adjusted. Minor adjustment can be made by
removing shims from behind the magnet. Major adjustments can be
made by moving the magnet to the outside of the panel.
Adjustment may be required to accommodate the door stop chain
slack when the control door is closed. The control door securing
screws can be loosened to allow adjustment. Before re-tightening
the screws ensure the control door is still recessed into the
frame at a
similar offset to the
top trim piece.
manual
frame on
frame with the two holes in the top trim bracket and secure
frame is perfectly square and the control
BOTTOM
TRIM
BRACKET
CONTROL
DOOR
frame on the bottom trim bracket.
frame with the holes in the bottom trim
TOP
TRIM
BRACKET
W415-2350 / 10.28.19
fi nishing
EN
TOP
TRIM
BRACKET
BOTTOM
TRIM
BRACKET
25