Environment Protection; Control Panel; Switching Off; Temperature Regulation - ZANKER ZKG8509 Notice D'utilisation

• This product must be serviced by an authorized
Service Centre, and only genuine spare parts must
be used.

Environment Protection

This appliance does not contain gasses which
could damage the ozone layer, in either its refrig-
erant circuit or insulation materials. The appliance shall

Control panel

1 Pilot light
2 Temperature regulator
3 Fast Freeze light
4 Fast Freeze switch
5 Alarm light
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The pilot light will light up.
Important! If the temperature inside the appliance is
too high the Alarm light will blink. Active the Fast Freeze
function.

Switching off

To turn off the appliance, turn the Temperature regu-
lator to the "O" position.
The pilot light will switch off.

Temperature regulation

The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower set-
tings to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.
16
1 2
not be discarded together with the urban refuse and
rubbish. The insulation foam contains flammable
gases: the appliance shall be disposed according to the
applicable regulations to obtain from your local author-
ities. Avoid damaging the cooling unit, especially at the
rear near the heat exchanger. The materials used on
this appliance marked by the symbol
3 4 5
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping
in mind that the temperature inside the appliance de-
pends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must
be set to a higher temperature to allow automatic
defrosting and therefore reduced energy consumption.
Fast Freeze function
You can activate the Fast Freeze function by pressing
the Fast Freeze switch.
The Fast Freeze light will light up.
This function stops automatically after 52 hours.
It is possible to deactivate the function at any time by
pressing Fast Freeze switch.
The Fast Freeze light will switch off.
Excessive temperature alarm
An increase in the temperature in a compartment (for
example due to an power failure) is indicated by flash-
ing of the Alarm light.
are recyclable.