Troubleshooting - Ohyama woozoo STF-DC15T Manuel D'utilisation

Troubleshooting

In condition that any abnormality is detected during usage, please confirm the following problems after reading the
operation manual carefully before you entrust to repair it.
Status
● Plug is not inserted into the
➡
Not running
➡
Keep oscillating ● Enable the Sleep mode
No oscillating
● The oscillating Up / Down angle
➡
(Up / Down);
Abnormal sound
The direction of the
● The timed power-on is set
air circulation fan
➡
does not recover
after stopping
After the Power
On / Off button
➡
is pressed, it will ● The oscillating mode is running
not stop running
immediately
➡
● The battery runs out
● The battery is placed in wrong
➡
The product
cannot be
● There is an obstacle between
controlled by
➡
the remote
control
● The remote is not pointing in
➡
● The product is shaking as it is
➡
Large running
noise
➡
● The front shield is not completely inserted
The product
● While oscillating, the
makes big noises ➡
while oscillating
The fan blades do
not rotate or rotate
➡
● Dust accumulation
slowly (They stop
rotating after 5 times)
➡
Low air volume
● Dust accumulation
If the problem is not solved with the above measures
Please consult to the shop or Iris Ohyama Europe B.V. by
calling the consultation number.
Possible cause
outlet correctly
is automatically changed
when the timed power-off is
enabled
direction (Anode and the cathode)
the remote control receiving
part and the remote control
the right direction
not placed in a good position
characteristic sound of the
motor will become louder
➡
● Reinstate the plug and turn on.
● The oscillating Up / Down mode is enabled
➡
automatically in the Sleep mode.( → P12)
● Stop at the upper part or lower part for a few
➡
seconds to adjust the oscillating range, then
there is abnormal sound, which is normal.
● After the timed power-on is set when the timed
power-off is enabled, the direction of the air
➡
circulation fan will stop running directly but not
return to the front and 15° downward.
● If the product stops running when the oscillating
➡
mode is enabled, it will stop running after
returning to the front and 15° downward.
➡
● Please replace the battery.( → P6)
● Please place the battery in correct direction.
➡
( → P6)
➡
● Please remove the obstacle.
● Please point the infrared emission unit of the
➡
remote control to the front receiving part of the
remote control within a distance of 5 m.
➡
● Please place it on level ground.
➡
● Please install the front shield correctly.
➡ ● It is normal.
● Please clean up the dust on the fan blades.
➡
( → P13)
➡
● Please maintain the product and clean dust.
● Do not disassemble, repair or
Warning
transform the product without
approval.
14
Remedy