Gregster GRG-ET-9800-iE Mode D'emploi page 18

5. ASSEMBLY INSTRUCTIONS
STEP 4
43
44L
25
12
37L
42
39 38 37R
41L
46
47
84
48
106
1. Attach the footplate support bars (41L& 41R)by sliding them onto the footplate bolt of
the lever connection. Secure each side with 1 set of Allen head screws (4), spring wash-
ers (5) and flat washers (85). Tighten securely and then attach the end cap (84) with one
screw each (106).
2. Attach the footplate support bars (41L& 41R) to the swivel rods (25). Secure with 1 set of
Allen head screws (42), flat washers (39) and nuts (38) each. Tighten fully.
3. Attach the plastic covers (37L & 37R) to the footplate support bars (41L&41R). Secure with
2 sets of screws (12 and 20) each.
4. Attach the footplates (44L& 44R) to the footplate support bars (41L& 41R). Secure with
4 sets of Allen head screws (43), flat washers (46), spring washers (47) and knurled-head
screw (48) each. Tighten the knurled-head screws securely with your hand.
GRG-ET-9800-iE-IM-DE+GB+FR-05.indb 34-35
20
25
44R
38 39
37L
42
41R
46
47
48
106
84
85 5
4
34
5. ASSEMBLY INSTRUCTIONS
STEP 5
37R
1. Install the bars (3L+3R) on the swiveling rods (24L, 25R). Secure with 4 sets of Allen head screws (9),
spring washers (5) and waved washers (8).
2. Install the fixed handlebar (19). Secure with 2 sets of Allen head screws (4), spring washers (5) and
waved washers (8). Guide the hand pulse cable (23) along the handlebar (19) through the hole in
the handlebar post (29) all the way to the upper opening in the computer mount.
3R
3L
9
8
9
5
8
25
35
4
5
8
19
23
20/6/2016 5:27 PM