Philips HQC483 Mode D'emploi page 11

1 Disconnect the appliance from the mains
and let the appliance run until the motor
stops.
C
2 Open and remove the cutting unit.
C
3 Remove the metal clip by means of a
screwdriver.
C
4 Open the housing.
Insert a screwdriver into one of the grooves next
to the socket for the appliance plug.Turn the
screwdriver to separate the two housing halves.
C
5 Insert a screwdriver into the small slot in
the printed circuit board marked with an
arrow. Push the screwdriver down until
part of the printed circuit board breaks
off.
C
6 Pull the battery out of the appliance.
Dispose of the battery and the other
components in an environmentally safe way.
Do not connect the appliance to the mains again
after the battery has been removed!
ENGLISH
13