Rear Panel - HEADRUSH Pedalboard Guide D'utilisation Rapide

Rear Panel

4 5 6
1. Power Input (IEC): Connect this input to a power outlet using the included power cable.
2. Power Switch: Press this button to turn HeadRush Pedalboard's power on. Press and hold this button to
turn HeadRush Pedalboard's power off.
3. Vent: Make sure this vent is unobstructed while using HeadRush Pedalboard.
4. Guitar Input (1/4"/6.35 mm, TS): Connect your guitar to this input using a standard instrument cable.
5. Expression Pedal Input (1/4"/6.35 mm, TRS): Connect an optional secondary expression pedal to this input
using a standard instrument cable.
6. Aux Input (1/8"/3.5 mm, TRS): Connect an optional audio source (e.g., smartphone, tablet, etc.) to this input
using an 1/8"/3.5 mm stereo cable.
7. Outputs (XLR): Connect these outputs to the inputs of your mixer, active loudspeaker, etc. If you only need to
use one output, use the one labeled L/Mono.
8. Ground-Lift Switch: Engage (depress) this switch to reduce hum or noise.
9. Outputs (1/4"/6.35 mm, TRS): Connect these outputs to the inputs of your amplifier, audio interface, etc. Set
the Amp/Line selector to the setting appropriate for the connected device. If you only need to use one
output, use the one labeled L/Mono.
10. Amp/Line Selector: Use this switch to select the level of the signal sent from the 1/4"/6.35 mm outputs.
When set to Amp, the output level will be +6 dBu for a standard guitar amplifier. When set to Line, output
level will be line-level, +18 dBu.
11. Phones Output (1/4"/6.35 mm, TRS): Connect standard 1/4" (6.35 mm) stereo headphones to this output.
Use the phones volume knob to control the volume level.
12. Send Outputs (1/4"/6.35 mm, TRS): Connect these outputs to the inputs of another effects module, an effect
pedal, or the effects loop return of an amplifier. Set the Rack/Stomp selector to the setting appropriate for
the connected device. If you only need to use one output, use the one labeled L/Mono.
13. Return Inputs (1/4"/6.35 mm, TRS): Connect these inputs to the outputs of another effects module, an effect
pedal, or the effects loop send of an amplifier. Set the Rack/Stomp selector to the setting appropriate for the
connected device. If you only need to use one output, use the one labeled L/Mono.
14. Rack/Stomp Selector: Use this switch to select the level of the signal sent from the send outputs to the
return inputs. When set to Rack, output level will be line-level, +18 dBu. When set to Stomp, the output level
will be +6 dBu like a standard guitar pedal ("stompbox").
15. MIDI Input (5-pin DIN): Use a standard MIDI cable to connect this input to the MIDI output of an optional
external MIDI device.
16. MIDI Output (5-pin DIN): Use a standard MIDI cable to connect this output to the MIDI input of an optional
external MIDI device.
17. USB Port: Connect this USB port to a computer using a standard USB cable. This connection allows
HeadRush Pedalboard to send and receive the digital audio signal to and from your computer. You can also
use this connection to import or export rigs, model presets, and setlists.
7 10
8 9
11 12
14
13 15 16
3
2
17
1
5