Bo Jungle B-Bottle Manuel page 4

1. Fill the measuring cup (a) with water to the appropriate indicator line
2. Pour water into the warmer base (b) – REMARK: for safety reasons, never fill the warmer base up to the edge
3. Insert the bottle in the warmer base (b)
4. Remove the adaptor ring (c) if the bottle is too large
5. Put the jar in the basket (e) and insert in the warmer base (b)
6. Press the "on" switch (d)
7. The indicator lamp inside the switch (d) will burn while the appliance is turned on. The appliance will
automatically turn itself off and will alert you when the bottles or jars are warm.
Recommended quantities of water to obtain a temperature of 30 to 33° C (calculated for a bottle made of
polypropylene and with a fixed bottom; the material and thickness of the bottle may have an influence on the
required amount of water, please adapt when necessary):
Quantity of milk in the bottle
60 ml
90 ml
120 ml
150 ml
180 ml
210 ml
240 ml
270 ml
300 ml
330 ml
Jar
120 g
200 g
250 g
CLEANING
- Please ensure that the power cord is unplugged and that the appliance is cold before cleaning or filling it.
- Use a damp cloth to clean the appliance.
- Do not use any cleaning products to clean the appliance.
- The adaptor ring, the measuring cup and the basket can be put in the dishwasher.
- In case a layer of scale has formed on the appliance, clean as follows:
o Mix 100 ml of water with 100
o Leave to act for 30 minutes
o Empty the warmer base and clean using a damp cloth
WHAT TO DO IF:
The bottle warmer does not heat up:
- Check that the appliance is properly plugged in
- Check if the "on" switch has been properly switched on
- Remove the layer of scale that has formed in the warmer base if necessary
The heating cycle takes too long or is too short:
- Check if there is not too much or too little water in the appliance
Quantity of water for a bottle at
room temperature
7 ml
8 ml
10 ml
11 ml
12 ml
13 ml
14 ml
15 ml
16 ml
17 ml
Quantity of water for a jar at
room temperature
10 ml
12 ml
15ml
ml of white vinegar and pour this solution into the warmer base
4
Quantity of water for a bottle
that has been cooled
10 ml
12 ml
12.5 ml
13 ml
13.5 ml
14 ml
14.5 ml
15 ml
15.5 ml
16 ml
Quantity of water for a jar that
has been cooled
18 ml
22 ml
28 ml