Main Components - Zibro Moonlighter Manuel D'utilisation

GENERAL DIRECTIONS FOR USE
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 53 ff.).
1
Remove all packaging materials (refer to Section A).
2
Fill the fuel tank and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. F).
3
Insert the batteries into the battery holder µ
(refer to Section A, Fig. D).
4
Check whether the combustion chamber
(refer to Section C, Fig. I).
5
Ignite the heater by turning the wick adjuster knob
the right as possible and then gently push down the igniter
lever (refer to Section C, Fig. H).
6
Prior to adjusting the flame (refer to Section D), let the heater
heat up for 10 to 15 minutes.
7
Switch off the heater (refer to Section E).
•
The first time you ignite your heater it will smell
like 'new' for a short time.
•
Store your fuel in a cool and dark place.
•
Fuel has a limited shelf life. Start every heating
season with new fuel.
•
The right quality of fuel will be assured, when
you use Zibro Extra or Zibro Kristal for your
heater.
•
If you change to another brand and/or type of
paraffin oil, you must first finish up all the
remaining fuel in the heater.
is fully upright
as far to

MAIN COMPONENTS

³
Safety button (for
emergency stop)
·
Wick adjuster knob
»
Igniter lever
Combustion chamber
´
Combustion chamber
handle
²
Fuel indicator
¶
Grill
º
Fuel tank
¾
Ignition coil
µ
Battery holder
¸
Carrying handle
¹
Fuel tank cap
4
51