Noritz NRC111-SV Manuel D'installation page 36

3.
Quick Connect Multi System Installation
• The Quick Connect Multi System allows the installation of two units together utilizing only the Quick
Connect Cord.
The Quick Connect Cord is 2m (6'). long. Install the units 50 - 457mm (2-18") apart from each
other to ensure the cord will be able to reach between the units. (See Typical Plumbing diagram).
(If the distance between the two units is too great, not only will the cord not be able to reach,
but the water temperature may also become unstable because of the difference in pipe length
between the two units).
System Diagram
Quick Connect
Cord
Typical Plumbing
Make this distance as short
as possible.
* The hot water temperature
will become unstable as the
pipe length increases.
• Insulate the hot water piping to prevent heat loss. Insulate and apply heating materials to the cold
water supply piping to prevent heat loss and freezing of pipes when exposed to excessively cold
temperatures.
36
Cord Cord
Connector Connector
Union
Quick Connect
Cord
Shutoff
Valve
Leave enough clearance around the plumbing to
apply insulation. It will be necessary to add
bends to the piping to ensure that this clearance
is available.
Terminal Block
Remote Controller
Remote Controller Cord
G
Distance at center: 515 - 922mm (20.3 - 36.3 in.)
Distance on sides
50 - 457mm (2 - 18 in.)
Union
Union
Gas Valve
Shutoff Valve
* When connecting two units, use only a
single remote controller.
Note: Connect the remote
controller to only one
of the units.
Gas Supply Piping
Cold Water Supply
Hot Water
Shutoff
Valve
Size the piping to allow for the maximum
flow rates of the units.
Hot Water
Cold Water