Installation Options; Strip Lights; Connection Modes - ETI Solid State Lighting 54296146 Guide D'utilisation Et D'entretien

Installation Options

The LED Retrofit Kit can be used to convert existing fixtures with up to four fluorescent T12 or T8 tubes.
NOTE: The brackets created from the Retrofit Bracket Plate (B) will not be required to convert some fixture types.

STRIP LIGHTS

Primary Application: 8-ft. Strip Lights
□ The conversion of 8-ft. Strip Lights requires the use of retrofit brackets created from the included Retrofit Bracket Plate (B).
Secondary Application: 4-ft. Strip Lights
□ When converting a 4-ft. Strip Light, only the two (2) end sections of the Retrofit Bracket Plate (B) are needed.
□ Depending on the fixture, the existing fixture brackets may be able to be used instead.
OTHER 4-FT. FIXTURES
□ The conversion of other types of 4-ft. fluorescent fixtures is less common using this LED Retrofit Kit, as the Retrofit Bracket Plate (B) is
not needed. Only the Non-shunted Sockets (C) will be required.

CONNECTION MODES

8-ft. Strip Lights
L N
L N
4-ft. Fluorescent Lights
L N L N L N
L N
5 WWW.ETiSSL.COM
Please contact 1-855-384-7754 or further assistance.