Forney 190 MULTI-PROCESSOR Mode D'emploi page 20

c. In MIG Welding, "GMAW" (with gas) for the connection of the ground cable connector
10. POSITIVE DINSE SOCKET:
a. In STICK Welding, "SMAW", for the connection of the ground cable connector (check
for correct polarity for the electrode you are going to use, refer to the information on its
box);
b. In FLUXCORE WIRE Welding, "FCAW", for the connection of the ground cable connector.
11. EURO CONNECT FOR ATTACHING THE MIG TORCH CABLE. In FLUXCORE WIRE
Welding, "FCAW", change the polarity of the Euro socket using the terminals on the Polarity
Change Board located inside the wire spool compartment above the wire feeder -19-). To
attach the Spool Gun, remove the standard MIG torch from the Euro Connect and connect
the Spool Gun. Also connect the Spool gun control lead to the seven pin connector (12) on
the front of the cabinet and switch the Local / Remote switch (20) to the Remote position.
12. 7 PIN CONNECTOR:
a. In STICK, "SMAW"Mode when Remote is selected with switch (20) for connecting the foot
remote control;
b. In TIG, "GTAW" Mode when Local is selected with switch (20), for connecting the TIG
torch trigger control cable;
c. In TIG, "GTAW" Mode when Remote is selected with switch (20) for connecting the
foot pedal remote control; in this case the TIG torch trigger control cable has to be
disconnected;
d. In MIG Welding, "GMAW", Manual and Synergic when Remote is selected with switch
(20), for connecting the Spool gun torch 7 pin male connector.
13. INPUT POWER CABLE (BACK OF MACHINE)
14. ON/OFF SWITCH (BACK OF MACHINE)
15. 2 ROLL ALUMINUM WIRE FEEDER
16. SLOPE UP TIME REGULATION POTENTIOMETER
17. BURN BACK TIME REGULATION POTENTIOMETER (B.B.T.)
18. POLARITY CHANGE TERMINALS FOR THE EURO SOCKET:
a. Positive polarity for MIG Welding, "GMAW";
b. Negative polarity for FLUXCORE WIRE Welding, "FCAW"
20
FIGURE 3
WWW.FORNEYIND.COM
19
16
17
18
15