Far Tools TE 907 Notice Originale page 26

EN
anchor point, a strap or a chain of towing). Never wind up
the cable directly around the object and do not hang the
hook of the cable after cable. This can damage the object to
pull along the cable.
4. Tighten the clutch button.
5. check that everything is in order (see the list of usual pre-
cautions and safety instructions).
Use the switch on the remote control to wrap the cable to
the desired point.
USE OF THE EMERGENCY HAND CRANK
Caution: Do not use the crank on a winch already in action.
This could damage the winch and hurt you.
When to use the emergency hand crank?
When the battery is discharged and the cable was still
charged, the crank can help release the cable and rewind. Do
not use the crank to operate the winch to load.
1. This winch has a capacity of 900 kg. In practice, you can use it to:
a. Pull up to 900 kg initially stopped, on flat ground.
b. Move a maximum 4.5 t craft on the water.
c. Maintain moving a vehicle of maximum 5.4 t.
2. The ability to traction decreases depending on the slope. For example, the ability to run password 5.4 t on flat ground to 0.5 t on
upward slope of 45 °.
Number of layers of winding
Lift load (kg)
182015-Manual-B.indd 26
PULLING CAPACITY
Weight
(Tons)
2730
2275
1820
1365
910
455
10°
PRODUCT LABEL
1. Turn to hand the clutch button clockwise clockwise to
load.
Place the handle on the big tree of the winch.
2. Place the end of the crank on the outside.
3. Turn the crank in the opposite direction of the clockwise
to tighten the cable.
Turn in a clockwise sense to relax the cable until it is
busiest.
MAINTENANCE
1. Lubricate the cable occasionally with light oil.
2. Grease the gears every 6 months. To do this, remove the
clutch button and separate the left and right housings. Use
any good grade waterproof grease.
20° 30°
Degrees of tilt
1 2
907 726 590
EN
40° 45°
3 4 5
499 454
03/04/2017 10:32