Bremshey Sport TREADLINE PACER Mode D'emploi page 3

spare part list): keep the assembly tools, as you may
need them e.g. for adjusting the equipment
In case of problems contact your Bremshey Sport
dealer. The directions left, right, front and back are
defined as seen from the exercising position. To avoid
injury, you must fold up the deck prior to lifting the
treadmill out of the box.
Locate the hardware bag and parts that are listed in
the chart below.
Lift up the upright, then place the screws (C) and
washers (D, E) inside holes at the bottom of the
upright. Tighten them well.
Bremshey_Pacer09_4_spareparts.indd 3
Put the console to the correct position. Tighten the
screws (C) and washers (D) inside holes at the top of
the upright.
Attach front sheet (B) with the screws (F, G) at the
front of the treadmill, and tighten them well.
POWER CORD AND GROUNDING
INSTRUCTIONS
Plug the socket end of the power cord into the
treadmill at the left front corner. Before connecting
the device to a power source, make sure that local
voltage matches that indicated on the type plate. The
treadmill operates at 110 V or 230 V.
This treadmill must be grounded. If it should
malfunction or breakdown, grounding provides a
path of least resistance for electrical current to reduce
the risk of electrical shock. This product is equipped
with a cord having an equipment-grounded conductor
and a grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed
and grounded in accordance with all local codes
and ordinances. Do not use extension cables when
connecting the equipment to the power source.
G B
3
22.5.2008 12:07:45