Running-In Your Speakers
Run your speakers in by playing normal music at low-mid listening levels for approximately 50-70 hours
play time. You may find the sound will continue to improve even after the 70 hour mark.
This can be done naturally over time: like a fine wine the performance will improve with age.
Alternatively if you wish to run the speakers continuously on loop you can decrease the audible volume/
presence by placing the speakers face-to-face so that the drivers/tweeters are directly aligned and as
close as possible. Then connect the amplifier to your speakers so that one is as normal (in phase): positive
to positive and negative to negative (red to red and black to black), and the other speaker out of phase:
positive to negative and negative to positive inputs on the speaker.
Retention Bolt Adjustment
The new Silver Series has a bolt-through driver fixing to reduce cabinet colouration. Each bolt acts as a
rigid brace, but also removes the need for conventional driver fixings as well, effectively decoupling the
driver and front baffle to eliminate a further source of resonance.
NOTE: Should this bolt become loose over time, or has worked loose during transit, then please use the
supplied hex key to tighten the bolt back up. This only needs to be a quarter turn after the strain has been
taken by the bolt.
Guarantee
Both the craftsmanship and the performance of this product is guaranteed against manufacturing defects
for the period of five years from the date of purchase (see conditions in the Important Safety Instructions
booklet), provided that the product was supplied by an authorised Monitor Audio retailer under the
consumer sale agreement.
To verify your manufacturer's warranty, please visit the online registration form at: monitoraudio.com
Owner Information
Product Details
Model:
Product Serial No:
Amp panel Serial No:
Date of Purchase:
Dealer Details
Dealer Name:
Address:
Post code:
E-mail address:
Monitor Audio reserves the right to alter specifications without notice.
8
Silver Series