IFM Electronic ecomat 200 Notice D'emploi page 11

Programming
For programming terminals 6 and 7 must be linked, e.g. by means of
a key switch.
1
Press this key to increment
2
Press this key to change
from one decade to the
3
(= acknowledgement of
the parameter address).
Press this key to increment
4
Press this key to change
from one decade to the
5
(= acknowledgement of
the parameter value).
Interrupt the supply voltage briefly so that the new parameters become effec-
tive.
If no key is pressed during the programming process for approx. 15s, the unit
will change into the operating mode with unchanged parameter values.
Operation of the unit is maintenance-free.
P
Press briefly.
in active decade.
other.
P
Press briefly
in active decade.
other.
P
Press briefly
The parameter address is
displayed, decade 2 is flashing.
The active decade is flashing.
The actuele parameter value is
displayed (1st place is flashing).
The active decade is flashing.
Changing into operating mode;
actual value is displayed.