Removal From Storage - Princess auto 8887101 Mode D'emploi

V1.0
AFTER EVERY USE
Clean the pump thoroughly.
STORAGE
The pump should not be stored outside; the pump could get damaged from
rain and ice. Keep the pump in a cool, dry place. Do not store the pump in
direct sunlight.

REMOVAL FROM STORAGE

Before using the pump again, first soak the pump so that any possible dirt
residues do not block the appliance.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Pump does not
run.
Pump runs but
does not pump
liquids.
Visit www.princessauto.com for more information
1/3 HP Portable Submersible Sump Pump
Possible Cause(s)
1. No power.
2. Motor overheats.
3. Ground Fault Circuit
Interrupter (GFCI) is
activated.
1. Suction opening is
blocked.
2. The pump draws in air.
3. The pump is blocked by
foreign contaminants.
Suggested Solution(s)
1. Check the cables, plug,
socket and fuse.
2a. Liquid temperature is too
high, eliminate the cause of
overheating.
2b. Blocked by foreign
contaminants, eliminate the
cause of overheating.
3. Switch on the GFCI, if it
happens again, contact a
qualified service technician.
1. Remove the blockage.
2a. Keep the pump at an angle
while submerging.
2b. Switch the pump on and off
several times in order to
expel the air.
3. Clean the pump.
8887101
9