ARIETE 2770 Mode D'emploi page 13

- Once the battery has been recharged, make sure that the handheld cleaner is correctly fitted into
the appliance body (S), press the ON/OFF button (L) and move the handle back (M) into the typical
position for use (Fig. 6).
- Clean large surfaces by pushing the brush (T) forwards.
This allows the vacuum cleaner to pick up fragments and dirt from the floor.
- To clean small surfaces and in corners, turn the stick cleaner in the opposite direction to move the
dirt and fragments so that they can be picked up.
IMPORTANT: switch off the stick cleaner immediately should anything become entangled inside the
brush, such as a piece of fabric, the fringe on a rug, etc.
- After cleaning, switch off the stick cleaner by pressing the ON/OFF button (L) again.
Handheld Cleaner
IMPORTANT: SWITCH OFF THE APPLIANCE AFTER USE AND BEFORE FITTING OR
REMOVING SINGLE PARTS AND BEFORE CLEANING.
- Holding the handle (M) of the appliance body (S) firmly, press the release button (O) and remove
the handheld cleaner (Fig. 7).
- Fit the required attachment to the end of the dust container (A), press the ON/OFF button (F) to
start the handheld cleaner, holding it by the special handgrip (G) (Fig. 8).
The relevant indicator (E) switches on when the battery is running down and it stays lit until the
battery is completely flat.
Refit the handheld cleaner into the appliance body (S) and recharge the appliance as described
previously.
- To refit the handheld cleaner into the appliance body (S), first remove the attachment fitted to the
cleaner by pulling it outwards, then place the end of the dust container (A) in the bottom of the
special housing in the appliance body (S) carefully pushing the handheld cleaner back until you
hear it click into place (Fig. 9).
IMPORTANT: Make sure that the handheld cleaner has been correctly fitted before using the appli-
ance in the standard way or recharging the battery.
CLEANING
IMPORTANT: NEVER PLACE THE APPLIANCE BODY, PLUG OR POWER CORD IN WATER OR
OTHER LIQUIDS; ALWAYS WIPE CLEAN WITH A DAMP CLOTH.
IMPORTANT: SWITCH OFF THE APPLIANCE AFTER USE AND BEFORE FITTING OR
REMOVING SINGLE PARTS AND BEFORE CLEANING.
- Only clean the power base (H) and appliance (S) with a damp cloth and some mild detergent, if
needed.
When cleaning the appliance, make sure that no type of liquid enters the cleaner.
Never use heavy-duty cleaning agents (stain removers or solvents) as they could corrode the
plastic.
- 11 -
EN