Reset To Factory Settings; After Use - Monacor VTM-15 Mode D'emploi

5 Operation
5.1 Direct settings
1) Adjust the brightness with the button
time the button is pressed, the brightness will
increase until the maximum is reached, then it will
be reset to the minimum value.
2) Adjust the contrast with the button
the button is pressed, the contrast will increase until
the maximum is reached, then it will be reset to the
minimum value.
3) Adjust the vertical image position with the button
(4). Each time the button is pressed, the image will
be shifted a little to the top until the highest position
is reached, then it will be reset to the lowest posi-
tion.
4) Adjust the horizontal image position with the button
(6). Each time the button is pressed, the image
will be shifted a little to the left until the left end posi-
tion is reached, then it will be reset to the right end
position.
5) For further settings, shortly press the button MENU
(1) to call the on-screen menu:
5.2 Settings via the on-screen menu
The following menu will appear on the VGA monitor:
The symbol of the first menu item "RESOLUTION" will
flash and the current setting will be displayed in the
centre, e. g. "1280 × 1024".
Select the desired menu item with the button
and change the value with the button
The following menu items are available:
RESOLUTION
The following screen resolutions are available:
640 × 480, 800 × 600, 1024 × 768, 1280 × 1024
FREQUENCY
Depending on the screen resolution selected, the fol-
lowing image frequencies are available:
Resolution Frequency
640 × 480 60/72/75/85 Hz
800 × 600 60/72/75/85 Hz
1024 × 768 60/70/75/85 Hz
1280 × 1024 60 Hz
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
(2). Each
(3). Each time
(6)
(4).
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
HUE
SATURATION
CONTRAST
BRIGHTNESS
The button MENU (1) will allow to exit the adjusting
menu at any time.
Note: If a setting is selected which cannot be correctly
reproduced by the monitor connected, the menu is
possibly no longer legible which makes further change
of the setting impossible. In this case, reset the VTM-
15 to its factory settings (

5.3 Reset to factory settings

To reset all menu settings, keep the button MENU (1)
pressed for more than 3 s. Thus, all settings made by
the user will be deleted and replaced by the factory
settings.

5.4 After use

To prevent unnecessary power consumption, discon-
nect the plug-in power supply unit from the mains
socket after use.
6 Specifications
Resolution: . . . . . . . .
Image frequency: . . .
System: . . . . . . . . . . . PAL
Video input/output: . . BNC
VGA output: . . . . . . . D-SUB, 15-pole, 0.7 Vpp RGB
Power supply: . . . . . . 5 V /400 mA via plug-in
Ambient temperature: 0 – 40 °C
Dimensions: . . . . . . . 133 × 76 × 44 mm
Weight: . . . . . . . . . . . 450 g
Subject to technical modification.
chapter 5.3).
table in chapter 5.2
table in chapter 5.2
power supply unit provided
and connected to
100 – 240 V~/50 – 60 Hz/5 VA
GB
7