Troubleshooting; Motor Overloading; Paper Jam; Maintenance And Service - Olympia PS 950 CCD Mode D'emploi

Troubleshooting

Motor overloading

The following can lead to the device being shutdown:
1. Motor overheating. If the device is used continuously for longer than
5 minutes, a motor circuit breaker switches the device off
automatically.
2. Exceeding the capacity, e.g. by inserting more than 12 sheet of 70 g
paper at a time.
3. Jammed paper when it is not gripped properly at the paper infeed,
i.e. it is drawn in crooked.

Paper jam

Always feed the paper straight into the paper infeed.
ATTENTION!
Never leave the shredder switched on when a paper jam occurs in order to
prevent injuries.
1. Disconnect the power plug from the power socket.
2. Cut or tear off the remaining paper above the shredder.
3. Connect the power plug to a power socket.
4. Set the AUTO, OFF, REV switch to AUTO.
5. If necessary, toggle the switch alternately between AUTO and REV
to loosen the jammed paper.
6. The residual paper is then ejected.
7. The shredder can now be operated normally again.
Note:
Frequent paper jams which cause the device to be shutdown by the
overheating protection facility can reduce the service life of the shredder.

Maintenance and Service

Disconnect the power plug prior to cleaning to prevent the risk of injuries.
Clean the housing with a slightly moist cloth.
Do not use any aggressive cleaning agents. Never use any chemicals (e.g.
cleaning solvent, alcohol) to clean the housing.
21