Cabinet Clearances; Front Grille; Installing Your Beverage Center; Leveling Legs - AGA marvel 6GARM Instructions D'installation, D'utilisation Et D'entretien

Select Location
The proper location will ensure peak performance of your ap-
pliance. We recommend a location where the unit will be out
of direct sunlight and away from heat sources. To ensure your
product performs to specifications the recommended installation
location temperature range is from 55 to 100°F (13 to 38°C).
Cabinet Clearance
Ventilation is required from the bottom front section of the unit.
Keep this area open and clear of any obstructions. Adjacent
cabinets and counter top can be installed around the unit as long
as the front grille remains unobstructed.

Front Grille

Do not obstruct the front grille. The openings within the front
grille allow air to flow through the condenser heat exchanger.
Restrictions to this air flow will result in increased energy usage
and loss of cooling capacity. For this reason it is important this
area to not be obstructed and the grille openings kept clean.
AGA MARVEL does not recommend the use of a custom made
grille as air flow may be restricted because of inadequate open-
ings. (See Figure 2).
Front

Leveling Legs

Figure 2

INSTALLING YOUR BEVERAGE CENTER

Front Grille, keep
this area open.
Rear
Leveling Legs
Leveling Legs
Adjustable legs at the front and rear corners of the unit should
be set so the unit is firmly positioned on the floor and level
from side to side and front to back. The overall height of your
Marvel appliance may be adjusted from 33 7/8" (86.1cm) with
the leveling legs turned in, and up to 34 7/8" (88.6cm) with the
leveling legs extended.
To adjust the leveling legs, place the appliance on a solid surface
and protect the floor beneath the legs to avoid scratching the
floor. With the assistance of another person, lean the appliance
back to access the front leveling legs. Raise or lower the legs to
the required dimension by turning the legs. Repeat this process
for the rear by tilting the appliance forward using caution. On
a level surface check the refrigerator for levelness and adjust
accordingly.
The front grille screws may be loosened and the grille adjusted
to the desired height. When adjustment is complete tighten the
two front grille screws. (See Figure 3).
Figure 3
4
Front grille
Front grille screw